The handle on a wolf range or wall oven should not be loose.
Tighten door handle sub zero.
Loosen the screw place the handle back on flush against the door surface and tighten the screw finger tight.
Refer to the images above.
Tighten the handle.
There should be a small set screw on the inside of the handle opposite side of the picture.
A 3 32 allan wrench is needed to tighten the set screw on a sub zero stainless steel handle.
Remove the molding trim from the hinge side of unit or bottom of drawer.
This video is about removing and re installing asub zero handle.
Remove the magnetic caps covering the side mounting brackets.
A small amount of blue loctite may also prevent the mounting stud from loosening in the.
The door must be partially disassembled to tighten the handle.
Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
Remove the screws from the side mounting brackets.
Remove the molding trim from the hinge side of unit or bottom of drawer.
Both l shaped and flat allan wrenches can be used.
Tighten the handle screws from the back side.
Remove the handle by removing the set screws from the underside of both handle standoffs.
This is usually driven with a small allen key.
Remove the magnetic caps covering the side mounting brackets.
It is between.
For allen wrench information see wrench size used to tighten a sub zero handle.
If the end caps are tight to the door and the handle is loose service is needed.
Designer formerly integrated series remove the molding trim from the door or drawer.
Remove the screws from the side mounting brackets.
See also sub zero 700 series panel removal.
Tighten the handle.
There is no direct metric equivalent for a 3 32 allen wrench.
Contact factory certified service to schedule an appointment for repair.
Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
Use whatever screwdriver or wrench is appropriate to tighten this screw and firm up the doorknob s grip on the spindle.
Once the handle and standoffs are removed from the door tighten the standoff mounting stud with a flat head screwdriver.