Tile Expansion Joint

According to the tile council of north america a body that helps set standards for tile installations when installing outdoor tile there must be an expansion joint every 8 feet to 12 feet in each direction.

Tile expansion joint.

An expansion joint is in the substrate for instance in concrete. Tile expansion joints tile doctor ceramic porcelain and stone tile expands and contracts with thermal and moisture changes in the environment. According to the ntca national tile contractors association reference manual an expansion joint is a joint through the tile mortar and reinforcing wire down to the substrate by integrating these stress relievers into the tile assembly expansion and contraction takes place without compromising its integrity. The tcna handbook recommends allowing for expansion and contraction in every tile installation.

The larger the tile field the more it will expand and contract and be vulnerable to failure. Latham standard loc strip hard flooring expansion joints are capable of absorbing extension and compression equivalent to 16 or 20 of the undeformed width of their elastic neoprene cores. Placement of expansion joints is very important. In almost every case the substrate will move differently to the covering material.

It is recommended that you err on the side of caution and use the smaller measurement. A movement joint is in the tile only. Schluter systems prefabricated movement joint profiles protect tile edges and prevent sound bridges and surface water penetration resulting in a permanent maintenance free installation. If you tile over an expansion joint then you need to honor that joint in the tile as well.

Including movement joints in floors enables the tile bed to move in unison with the individual substrates. Where should movement joints be placed. Expansion joints are a necessary installation on large areas of tiling. Learn all about expansion joints here.

The use of expansion or movement joints is to safely absorb the movement in the floor or wall from heat expansion or vibration. It s quite common to see controlled breaks in concrete and those are usually expansion joints. Recognizing that tile is a facade movement joints are needed to eliminate stresses that can occur between the substrate and the tile due to differing amounts of expansion and contraction. It allows for movement in the tile.